Sound Projects - SP215

Sound Projects - SP215

The SP215 is an elegant and slim self-powered sublow system. The cabinet is constructed of a rigid, multilayer, cross grain birch plywood. Additionally braced with multiple reinforcement ribs and finished with a sturdy nano-armor™ coating.

Sound Projects SALC speaker management electronics and a proprietary 2500W CoolClass-D™ amplifier section power the two longstroke 15-inch drivers. This combination boasts an impressive 142dB SPL augmenting the low-end response of the full range and high/mid systems down to 30Hz, the deep sub you can feel.

The SP215 is cosmetically interchangeable with all SPX systems and will effortlessly add a tight kick to any rock concert as well as a fat old moog groove to a dance party.

Acoustical specifications

• Drivers: 2 x 15" High Power, low distortion, long excursion design. Double, impregnated spider and ventilated coil airgap for reduced power compression.
• Freq. Reponse: 30-60Hz/FR switchable: Sub Mode/FR (ext. LP filter)
• Max. peak SPL @ 1m: 142dB (Peak level at 1M under half space conditions using pink noise with crest factor 4 (12dB))
• Coverage angle: Omni-directional

Electrical specifications

• Amplifier(s): CCD(TM) technology
• Output: 2500W sine (SALC limited) Specified at 4 ohm
• Filter subsonic: 30Hz, 2nd order
• Low pass 4th order: 60Hz / Full range (switchable) Fixed filter on request
• Input impedance: 20 kOhms balanced, 10 kOhms unbalanced
• Output impedance: Hard-wired to input
• Main voltage: 230V (other on request)
• Mains frequency: 50 / 60 Hz
• Idle: < 50VA
• Full load: < 3000VA. DALC limited Ref. to continuous pink noise signal (12 dB crest factor within the specified range)
• Protection: S.A.L.C. (Single Audio Logic Control)

Additional descriptive data

• Cabinet construction: Cross grain laminated multiplex
• Finish: Nano-armor(TM) coating
• Weight (in KG): 72
• With (in mm): 450
• Height (in mm): 1200
• Depth (in mm): 600
• Depth with wheels (in mm): 730
• Rigging points: M20 polemount
• Audio connectors: IEC XLR-3 in/out
• Main connectors: Powercon in, powercon out
• Max operating temp.: -10 to 40 C ambient