Sound Projects - X-tender

Sound Projects - X-tender

The SOUND PROJECTS X-tender is an unsurpassed light weight and low profile self-powered loudspeaker system. The rounded, sleek cabinet design easily merges into any stage set up. A near perfect balance between frequency and power response allows a very high gain before feedback. A very efficient 15-inch low frequency driver effectively loads a 3-inch diaphragm compression driver. The custom coaxial transducer configuration is carefully tuned to a 80° point source to effectively
dampen potentially harmful peaks.

In monitoring situations the X-tenders performs with a smooth tonal response providing exceptional immunity to feedback. The smooth off-axis roll-off presents a comfortable and predictable sweetspot for the performer. A convenient feature for vocalists, the monitor mixer and stage crew. The X-tender can be used in two specific floor monitor working angles; relative to the floor a 30° angle for short throw and 60° angle for long throw on deeper stages.

The integrated singlehand carry handle and its low weight of 19 kg (less than 40 Lbs) make the X-tender a pleasure to move around. Even carrying two floors at a time is no problem, saving time and manpower. The bracket (optional) extends the versatile use of the X-tender. With the included polemount it easily turns the X-tender into a fullrange F.O.H system. And without the polemount the bracket facilitates to rig the X-tender underneath a truss or (balcony)ceiling.

Acoustical specifications

• Drivers: 1 x 3" HF (1,4" exit), 1 x 15" L1 x 3" HF (1,4" exit), 1 x 15" LF High power low weight neodymium design.
• Freq. Reponse: 50Hz-20kHz
• Max. peak SPL @ 1m: 138dB (Peak level at 1M under half space conditions using pink noise with crest factor 4 (12dB))
• Coverage angle: 80 spherical, soft roll-off

Electrical specifications

• Amplifier(s): CCD(TM) technology
• Output: 1200W* sine LF/100W sine HF (DALC limited) (Specified at 8 ohm)
• Filter hipass: 50Hz, 4th order
• Crossover: 1.4 kHz, 4th order
• Input impedance: 20 kOhms balanced, 10 kOhms unbalanced
• Output impedance: Hard-wired to input
• Main voltage: 230V (other on request)
• Mains frequency: 50 / 60 Hz
• Idle: < 50VA
• Full load: < 1200VA. DALC limited Ref. to continuous pink noise signal (12 dB crest factor within the specified range)
• Protection: D.A.L.C. (Dual Audio Logic Control)

Additional descriptive data

• Cabinet construction: Cross grain laminated multiplex
• Finish: Nano-armor(TM) coating
• Weight (in KG): 19
• Width (in mm): 450
• Height (in mm): 320
• Depth (in mm): 540
• Rigging points: Fixing points M8 for flying bracket / pole mount (optional)
• Audio connectors: IEC XLR-3 in/out
• Main connectors: Powercon in, powercon out
• Max operating temp.: -10 to 40 C ambient